"Your resource throughout the generations"

Healthcare Projects

VA B100 EMERGENCY ROOM EXPANSION

 

Seattle, Washington
Owner: VA Puget Sound Health Care System
 

This project involved geotechnical engineering study for a future emergency room expansion for VA Puget Sound Health Care System. Our scope of services included a reconnaissance of the site by the geotechnical engineer, a review of geologic literature, and drilling of two borings. The geotechnical engineering services were performed by ORA to provide the following information:

  • seismic design considerations including liquefaction potential,

  • suitable foundation systems with estimated settlements,

  • allowable bearing capacity for the design of shallow foundations, if appropriate,

  • recommendations for the design of deep foundation, if appropriate,

  • lateral earth pressures and friction coefficients for the design of below-grade walls and retaining walls,

  • influence of groundwater on the development, and

  • site preparation and earthwork recommendations.

We are also engaged to provided on-call geotechnical and structural inspection services during construction.

 


 

HARBORVIEW MEDICAL CENTER EXPANSION

 

Seattle, Washington
Owner: King County
Size: 8 stories and 520,000 sq ft
Project Cost $103.7 million

 

 

 

 

 

 

Major addition to the Medical Center, consisting of an eight-level trauma center and two new wings that includes a nine-level northwest tower and a seven-level southwest tower. ORA was engaged to provide complete structural inspections and materials testing services for this capital project over a duration of approximately three years. The complexity of this project required a resident inspector assigned with quality control.

 

Testing and inspection services performed by Otto Rosenau & Associates, Inc. include:

  • Reinforced Concrete (cast-in-place)

  • Batch Plant Inspection

  • Precast Fabrication/Erection

  • Tieback Grout Strength

  • Structural Steel Fabrication and Erection

  • Shoring/Tieback Welding

  • Full Penetration Welds (Ductile Frame)

  • Steel Decking

  • Prefabricated Stair Erection

  • Spray-Applied Fireproofing

  • Steel Joist Erection

  • Structural Steel Embedments in Concrete

  • Reinforced Masonry

  • Curtain Wall Fabrication/Erection

  • Anchor Bolt/Expansion Anchor Installation

  • Epoxy Grouting


OVERLAKE MOB AND PARKING GARAGE

 

Bellevue, Washington
Owner: Overlake Medical Tower LLC
Size: 455,00 sq ft
Project Cost: 54 million

 

 

 

 

 

 

 

 

Major addition located at the Overlake Hospital Medical Center that includes a 6 stories medical office building and a parking garage. The medical office tower contains services such as an ambulatory care center, a cancer center, a pharmacy and a children's hospital specialties clinic.

 

Otto Rosenau & Associates, Inc. was engaged to provide complete structural inspections and materials testing services for the project over a duration of approximately 1 ½ years. This project also required a full time resident inspector.

Testing and inspection services performed by Otto Rosenau & Associates, Inc. include:

  • Reinforcing Steel

  • Tieback Grouting

  • Stressing of Tiebacks

  • Reinforced Concrete

  • Post-Tension Tendons Installation, Stressing, and Elongation

  • Epoxy Grouting

  • Spray-Applied Fireproofing

  • Dry Pack Grout

  • Precast Erection

  • Structural Steel Erection to Include Welding and Steel Decking


SWEDISH MEDICAL CENTER SE TOWER

 

Seattle, Washington
Owner: Swedish Medical Center
Size: 11 stories and 207,649 sq ft

 

 

 

 

 

 

 

 

 

 

 

 

This project is a continuation from the original 3-story SE Wing with the new construction of a 11-story structural steel frame addition above the existing structure. The new tower includes an Oncology Center, Physical Medicine and Critical Care Units, Women and Children's Center, and the expansion of an existing Birthing Center.

 

ORA was engaged to perform onsite structural inspections and materials testing services as well as overseas structural steel fabrication inspection and nondestructive examination. Structural steel was fabricated by Samsung Heavy Industries in South Korea at their Tangjin plant. Built-up columns were fabricated by Kawasaki Steel Corporation's subsidiary company, Kawatetsu Metal Fabrica Corporation, located in Marugame, Japan.

 

Testing and inspection services performed by Otto Rosenau & Associates, Inc. include:

  • Reinforced Concrete (Cast-in-Place)

  • Structural Steel Fabrication - Overseas

  • Structural Steel Erection

  • Steel Decking

  • Structural Steel Embedments in Concrete

  • Epoxy Grouting

  • Expansion Anchor Bolt Installation

  • Curtain Wall Fabrication and Erection

  • Full Penetration Welds Inspection

  • NDE for Special Moment Resisting Frame